Recent content by Daniel Malloy

I had a max on time of 2 seconds and it went passed that and filled it to the top of the sensor anyway. Then it sent me an alert saying max on time had been exceeded. I just turned off advanced settings and it still did the same thing. Weird man, I dunno?..

The output was drive port 2 and sense port 2. Yes I tried only 1 2 and 3 seconds but it kept filling it to the upper part of the sensor.

I tried fixing it that way but it kept going over my max on time, trying to make it to that top part/ sensor or whatever.

I appreciate you sending me a new water level sensor! I will try it and hopefully that is the issue and not something else. I'm just using the control 2 with a temperature probe (the magnet one) and the ATO pump and sensor. That's all except for the Wave Engine but it just runs my 2 ice cap...

I'm only using the one water level sensor. There are 2 optical sensors on one SINGLE sensor. Mine was starting to fill at the low one.. then would dump a bunch of RODI (ran for around 5-6 seconds) and it would fill up to the High one. My tank is only 50 gallon with a 29 sump so that is way too...

I'm just trying out the ATO using the control 2. For some reason it starts filling when the water trips the lower level and runs for like 5 seconds filling it all the way to the high level on the sensor. Which is odd and I'm hoping it's something I'm doing wrong?..