Danny's latest activity
-
Danny replied to the thread Ato/awc cycling.Glad to hear it is resolved. -
Danny replied to the thread Ato/awc cycling.It still would not hurt to have others check it and see if they notice anything that might be causing your issue. I assume you have...
-
Danny replied to the thread Ato/awc cycling.You changed a setting from twice a week to once a week? Could that have been what caused the issue to show up? My AWC is split into 4...
-
Danny replied to the thread Kraken 24V Force Port extension cable?.I do that for power to my lighting but my lighting is a DIY LED fixture. I may have made my own cable at the time since the Kraken was...
-
Danny replied to the thread Hydros power alert 0 watts.Have you tried rebooting the XP8 from the right menu under device properties?
-
Danny replied to the thread No Push Notifications from Launch.Try turning them off in options. Then do the upload changes. Then wait a couple of minutes and then turn them back on again and upload...
-
Danny replied to the thread Initial Setup Issues with WaveEngine2 and Octo Pulse 4's.I am not sure that is what happened or not but that was what I thought might have caused it since it seemed to start woking overnight...
-
Danny replied to the thread Initial Setup Issues with WaveEngine2 and Octo Pulse 4's.If it was you first post it was probably not visible to anyone for a period of time. Today is the first time I noticed either post. The...
-
Danny replied to the thread Dosing container volume issue with Sole.It will do that if you run it backwards since the dose is counted as a negative dose instead of a positive dose. You can always switch...
-
Danny replied to the thread Minnow Not Responding.There is a Hydros dosing pump that is called "Simple Doser". It hooks to a drive port and runs when powered. It is just single speed...
-
Danny replied to the thread Minnow Not Responding.Can you post screenshots of your output settings and the settings in the schedule. The Minnow dosing pumps are smart dosers and need to...
-
Danny replied to the thread Bad Kraken PSU???.You did have the battery disconnected when you did the power down reset? The only other thing I can think of is it was not powered down...
-
Danny replied to the thread Bad Kraken PSU???.Is this the same person with the issue on the facebook group?
-
Danny replied to the thread AWC Setup on Waterbox P25.Here is a link to my build thread on Reef Central and on page 11 it has the way I currently have mine setup using smart dosing pumps...
-
Danny replied to the thread AWC Setup on Waterbox P25.Also to use the built in AWC the ATO pump has to be a part of it and also the high level sensor is also the ATO sensor so not sure that...