Recent content by Karliefish

Can someone explain the difference between turning-on the “Invert Rotation” setting and turing-on the ”Allow Reverse” setting when using Gyre Pumps? What happens to the Gyre pump motion when these are activated separately, i.e., “Invert Rotation” is only turned-on? and what happens when “Allow...

I had this same problem when i was first setting up my GYRE pumps. The instructions are not clear on the need to set to “normal”. Might want to make this setup instructions easier for us newbies

Carlos. Your instructions were terrific and I’ve got my Gyres, Vortech and Abyzz pumps all running at 5% during feed mode. I would suggest that you add a step (or comment) that you want to activate the feed mode from the Apex if using an Apex controller. This is including in your other...

HI everyone - my first post today! Just got my brand new Wave Engine setup - so far so good, though I have to admit working your way through "pumps", "modes", "pre-sets" and "triggers" can be a bit daunting at the beginning. One of reasons I bought this device was that it was advertised to...

I just setup my new Hydros Wave Engine with the Maxspect XF350 pumps and I'm experiencing the same errors where the Hydros app is telling me that the pumps are "locking-up". I have to reset the system to get this problem to stop. I haven't been able to get any explanation on what is going on...