Recent content by robert404

Hello, What adapter or cable will I need to connect the DX18 to a Control x4 0-10 port. The terminator bus and hack it to use the negative and positive? If others have done this would be interested in your setup. I don't want to burn anything up! Thanks, Robert

Thanks Danny. Helpful! I'm going to go for it with the HYDROS Dosing Pumps

Hello, A couple questions to those using the HYDROS Dosing Pump for ATO and/or Water Changes. My distance between water station and sump/tank: 6' Feet Up, 60' Feet Over, and 4' Feet Up 1. Are my distances too much for these little pumps? 2. Are dosing pumps in general better at sucking or...

Does anyone know when/if these AutoAqua sensors will be available?

I'm starting to figure this out - very good. Is it possible to have 2 "depends on" statements with the ATO? 1. Depends on Sensor 1 / Off if On (Display is MAX Full) 2. Depends on Sensor 2 / Off if On (Resivoir is empty)

I have a stand alone sensor that is higher than the ATO fill sensor I want to use as a failsafe to disable the ATO Pump. I’m able to accomplish part of this now with alerts and a MODE that allows me to kill the ATO. However if the control thinks the sensor is good but is actually inop for some...

Just to close this out, when using the ATO Pump output, and changing modes for example ATO OFF, it did turn off while it was running. We're good to go. Thank you.

All very helpful thank you. And on the ATO Pump output the maximum on time (00:02:00) and the maximum off time (23:59:59) will cover me in the following 2 scenarios I expect: 1. maximum on time: pump will not run more than 2 minutes 2. pump will stay off for at least 23:59:59 hours/minutes...

Ok I follow you, but the only reason I wanted to add DSPL Level output, was so that I would get an alert when the sensor was dry, this triggers me to monitor the ATO output action and fill up process. But I think this will be ok I just need to remove it as a dependency from the ATO actions all...

Only using drive port 1, and is connected to the micro pump in the reservoir

"The Depends On conditional is an absolute override and does not follow the min/max on/off timers." This is the info I was missing. I'm going by trial and error on first setup. Is there a guide that defines what each of the fields and values conform to along with their limits etc.

I'm not following you on this. Here is what I have setup now, should this work if I select mode ATO OFF while it is running?

I ran this test tonight with the ATO using modes. From normal mode the ATO process kicked off and was running then I flipped it to ATO off mode and the ATO continued to run and did not turn off. I understand i could go right to the output and select off to stop the pump, however the ATO Off mode...

C2 with ATO setup on a fresh tank, simple. If maximum on time is reached the alert is sent - good to go. How can I set this up so that if maximum on time is reached it sends an alert and kills/turns off the Output Device (in this case drive 1). Alert is great but if I’m remote and in bad cell...

Very helpful, I was stumped looking for how to set a basic RED notification if my RODI tank overfilled!