Recent content by Straasha

I use two of these pumps in my basement to pump RODI and Saltwater up to my tank on the main floor for the AWC/ATO schedule. 12V DC DIY Peristaltic Liquid Pump Dosing Pump for Aquarium Lab Analytical 170~460mL/min. Not sure if I can post where I bought them but... I also adapted them to work...

I am controlling two Jebao wavemakers with a Hydros APX interface cable connected to a single 0-10v output from my X4. Just follow the instructions above. Easy Peasy.

Here is what I am thinking. I currently have an X4. If I used the PH Probe that came with my X4, the new Minnow, the iV connect to an X4 drive port, and the HYDROS 2mL/min Dosing Pump for the reagent, I think I would be able to conduct the Alk testing without buying the X10. What does the...

If you have the XP8, you could do the opposite. Set your controller to be 3 degrees higher than Hydros and then let Hydros turn the controller/heaters on and off. This will allow you to monitor the power output from the heaters and to know when one of them has failed. If you did it the other...

You will want to set the Total Dose per Pump to be 4 ml. Then set your Dose Count to 2. Now I am not sure about crossing days. I would think you would set the time from 0200 to 0200. It will then divide the time by 2 dosing at 0200 and 1400.

The Hydros instructions will tell you how to prime. HYDROS Control - How To Add a Simple Doser Output Prime the Simple Doser Before you calibrate the unit, you must prime the line. Priming the line means removing all the air from the lines. To prime the line: Place the output line of your...