Recent content by TheHunterYall

Instructions included access point but some reviews state otherwise. I’m gonna return and get the 3700

I got the net gear ex6120 ac1200. Was only a few bucks more and had more range. Bad move?

Yes, I hard wired. But if not in bridge mode the net gear will not let me get passed the choose access point phase. It does broadcast a net gear wifi before that but then both Wi-Fi’s are kinda messing each other up I think. But again I am unable to get thru the access point menu. After...

I have the latest xfi xfinity router/modem, white 3rd gen. It is mesh and have 2 of their pods/extenders going. It is very stable, just one of the wifi outlets goes offline now and then but has been awhile. I got the recommended Amazon extender because I figured why not create the recommended...

No, other monitor reads 850

Sorry, meant to report that, it’s reading 1.15 volts

Seems to be working. I have the humidity and temp sensor powered as well. And a reed switch. How about the slope and offset? What should be right?

This is timely, I just hooked this sensor up to your breakout box yesterday. I thought the slope and offset would be straight forward but I am questioning the reading, seems to read twice as high compared to my desktop unit. I am using 3125 for the slope and -1250 for the offset. But the...

Only have 2 ports open

Yeah, watched it, was vague. “In about a week”. Didn’t get the other answers. I’d order 2 or 3 right now.

So when can I get my hands on these? And where online? Also, how many can I drive from a single drive port? Just one or will I be able to split them like the Klir?

Am I doing this efficiently? I need to create a generic output from an input, let’s say a level sensor, to be able to shut off a wave engine driven pump using depends on? Seemed like an extra step. Depends on was in schedules, didn’t see anything in the flow pump output.

I simply plugged in the hydros 0-10 volt cable 3.5 jack into the kessil, let me control intensity only. The one with the 4 colors. FYI. Might try this for fun, as I am experimenting with a fuge light.

I have not tried on any other ports. Used port 1 the whole time. I can experiment with others or do any other experiments you can think of as I am in the middle of a slow tank transition anyway. Agree with staying on same page. Thanks for the info.

Cool! Actually, I did get it to work but I’m not 100% confident. This is all new equipment. And the WaveEngine is not part of my collective yet as I do not have the data cable yet. I ran the pump in my sink with the Octo controls and it ran fine. I then looked at the direct drive cable...