Output Triggered on Switch Counter, How to?

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

H

Hkinkade

New member
Joined
Jun 4, 2025
Messages
19
Reaction score
2
Location
Calif
I want to trigger an output based on a counter. For example I want a drive port to be turned off after a momentary switch is activated N times. Can this be accomplished?
 
This is not supported natively in HYDROS right now. Counters cannot be used directly as a trigger condition for outputs. You would need an external controller or logic device to count presses and then send a single on or off signal to HYDROS. It may be possible in the future if logic rules are expanded by CoralVue, but today it cannot be done internally.
 
You must log in or register to reply here.
Back
Top