Search results

ATO. You are correct it's not labeled "High Water Sensor" it's just called "Level Input". I am able to leave it undefined which just turns on the ATO immediately and it doesn't stop. Check out the screenshot showing me uploading an ATO output without the level sensor defined.

I setup my ATO without a high water sensor definition on accident. I feel like an ATO without a sensor is uncommon and a potentially damaging mistake. I would consider inserting a warning before confirming that routine without a sensor or something that would stop it. I was fortunately...

It continued to do the saltwater top off for at least 3 hours. I deleted the AWC because I didnt want to throw off my salt levels, The ATO did not run a single time when it’s in this state. I’m using Hydros dosing pumps directly to the drive ports. The water is a few feet below the tank.

I just recently set up an Automatic Water Change output, and a schedule. The AWC is functioning (completes a drain and fill), but I'm getting these random frequent (top offs?), where the salt water fill pump runs for about 10 seconds. See the attached screenshot with the logs. My schedule for...