Search results

Hello, What adapter or cable will I need to connect the DX18 to a Control x4 0-10 port. The terminator bus and hack it to use the negative and positive? If others have done this would be interested in your setup. I don't want to burn anything up! Thanks, Robert

Hello, A couple questions to those using the HYDROS Dosing Pump for ATO and/or Water Changes. My distance between water station and sump/tank: 6' Feet Up, 60' Feet Over, and 4' Feet Up 1. Are my distances too much for these little pumps? 2. Are dosing pumps in general better at sucking or...

I have a stand alone sensor that is higher than the ATO fill sensor I want to use as a failsafe to disable the ATO Pump. I’m able to accomplish part of this now with alerts and a MODE that allows me to kill the ATO. However if the control thinks the sensor is good but is actually inop for some...

I ran this test tonight with the ATO using modes. From normal mode the ATO process kicked off and was running then I flipped it to ATO off mode and the ATO continued to run and did not turn off. I understand i could go right to the output and select off to stop the pump, however the ATO Off mode...

C2 with ATO setup on a fresh tank, simple. If maximum on time is reached the alert is sent - good to go. How can I set this up so that if maximum on time is reached it sends an alert and kills/turns off the Output Device (in this case drive 1). Alert is great but if I’m remote and in bad cell...