Search results

  1. B

    Can’t connect my Tunze via 0-10v

    I have no idea why no response? I settled 0-6.5V for my Tunze 6050 Does anyone have experience can share thank
  2. B

    Rope link sensor

    Hi I just wondering do I need to connect 2 side of the rope link ? 1 side I plug with the sensor but another side where I should plug ? I did setup the sensor in the system but seem no response when I try using the water to test but all the time mention it’s “dry”. thank
  3. B

    Anyone set up auto water change ?

    can anyone setup the auto water change Can share how to DIY via hydros system? Can share which gear or part need to purchase on the list thank
  4. B

    Drive port

    Hi Can I using the “ Klir Drive port adapter” to drive a small water pump 12V 10W, thank
  5. B

    Can I using the ATO kit for overflow pump

    Hi, Can I’m change the setting by using the ATO kit to converter to overflow pump. I mean once the water level over the pre-set point then that ATO helping me to drill out the water ? If can would I know How to setup ? Thank
  6. B

    WaveEngine with Tunze

    Hi Is there anyway or DIY I can direct connect the Tunze 6045 to WaveEngine and use as controller?
  7. B

    Wave engine connect to Tunze

    Hi everyone This is Brian I’m newbie to Hydros Currently I m running 120G reef tank Recently I just into hydros system X4 n WaveEngine. on my Tunze nano-stream 6055 n 6040 I can use the 0-10V plus adopter to connect WaveEngine in between the Tunze controller. I just wondering is it have...
Back
Top