Search results

Should these ever be able to run at the same time?

I would like to see Graphs when my outputs turn on/off. I find myself using the logs a lot for understanding when certain output actions occur, and it would be really nice to see them graphically. This could be especially useful with the graph overlay feature that is available on inputs (for...

Any recommendations for cleaning sand with an AWC system? I'm planning to use a syphon (like this) to clean the sand, which will drain the tank. I was thinking I would do the syphon manually, then run the AWC fill routine to replenish salt water to the high water sensor. I'm not sure how to...

Is there a way to have a water level sensor tile turn red when its status is dry? I can only get it to turn red if it's wet. I have low sensors in my AWC and ATO tanks, and want the tile to turn red when the water is low (state is dry). In the screenshot attached, I'm trying to invert those...

I setup my ATO without a high water sensor definition on accident. I feel like an ATO without a sensor is uncommon and a potentially damaging mistake. I would consider inserting a warning before confirming that routine without a sensor or something that would stop it. I was fortunately...

I just recently set up an Automatic Water Change output, and a schedule. The AWC is functioning (completes a drain and fill), but I'm getting these random frequent (top offs?), where the salt water fill pump runs for about 10 seconds. See the attached screenshot with the logs. My schedule for...