Search results

Sorry if I missed this already being asked. As far as I can tell the new App/software allows an alarm for Protein Skimmer sensor. However, it appears to alert when dry. Shouldn’t alert when wet?

Like the title says the web and app stauts has lost ability to graph. I have logged out, switched between text, tile, and graph several times. I have not powered off Control 4, wondering if this is next step. Nothing with unit/system has changed since doing update when it came out.

I received my Magnetic Stirrer today and I want to set it up to run for 5 minutes every hour. It is currently plugged in to one of my Wifi Power Strip Outlets. I started to set it up as a Generic Output with Input Count as Zero (0). I turned Has Schedule on but I am confused by the Advanced...

My tank overflows to my basement sump and I keep all of my equipment downstairs including my doser which I have not been using very long. Today I noticed a large ball in my coralbox 3 compartment dosing container. I think this is mostly due to my cold basement but also due to not stirring enough...

I have a Water Level Sensor in my sump that when DRY activates my Drive Port Pump to add top off water. Today I added a sensor to my RODI bucket to lmk when the water level drops too low. I am unable to figure out how to have the RODI sensor shut the Drive Port Pump off when the sensor goes dry...

I want to set up water change mode so that the Temp Sensor and the Water Level Sensor for my ATO do not alert when I chose this mode. I can't seem to figure out where I can have these sensors "turn off" when I run this mode. Thanks

I need help with Advanced Settings for my skimmer in feed mode. My skimmer is the only Output that is programmed to turn off in Feeding Mode (15 minutes). However at the end of 15 minutes the Protein Skimmer does not turn back on. Below is a pic of Advanced Settings:

I received my Hydros Controller 4 today and began the set up process. Things went well to start, anything that directly plugged in was easy to set up but when I tried to connect to the power strip and single plug I ran in to some difficulty. Was finally able to get these to appear in the app...