Search results

I have a new orp probe installed for about 2weeks and my hydros x4 constantly reads -512 anyone have any ideas why this is happening ? I have another prob on order in case the first one is bad.

Di you have any carbon by the output of your sjimmer? Also my plan was to have the skimmer draw the air in but a could use a air pump if that is more effective. To confirm your setup you basically just turn off and on the ozonater with hydros and set the amount of Ozone used on the enaly no need...

Are there any specific settings on the ozonator that I need to set thanks for the reply

Yes I am looking to use the orp probe connected to the hydros not the enaly

Is anybody using the control 4 to run the enaly Ozone generator looking for setup ideas

I have started a new tank with all new equipment (hydros) and such my old tank did fine on the Berlin method and I might still go back to a form of that I just wanted to try a new technique and this method interest me but dose seem there could be dangers that could arise thanks again for your...

I think will order a hydros dosing pump and go with solution your help would be greatly appreciated. Are you by chance using the aci method and whatcare your thoughts / results if you are

Bamatter. Another ? On the dosing of the kalk. last night I had a ph of 7.9 at 9 pm I used the dosing pump to replace my evaporation for 12 hours and had my wife turn off the pump manually. During that time the ph rose to 8.31 currently at 445 pm my ph is 8.25 my ? Is if I use the same method...

Great help guys I got the kamoer app trying to figure out if I can program it to turn on and off at certain times if not I will probably get the hydros pump I believe I can set the flow rate for that pump correct? Might just be easier to use that then

Thanks guys does anyone know if my pump could use the power source from the hydros dosing pump since there both made by kamoer

Kamoer x1 pro t2 is my pump

Ok thanks I will have to come up with another plan then

Thanks for the reply. I think I need to give you some more information on my setup. Using the control 4 with a kamoer pump plugged into the wifi strip. I have it to turn on at 10pm and off at 10 am currently to replace my evaporation with the kalk that is how I turn on the pump. With your...

Bamatter I am going to use the aci method for ph stability could you share a step by step process to have the ph probe turn off dosing at a set ph target? I will be using a dosing pump plugged into the hydros wifi strip and adding the kalk after lights out for 12 hours or so.i have my...

Figured it out if you make adjustments directly from the pump it overrides the app settings and vice versa.

Thanks for the reply. I'm trying to use this pump as a continuous drip for kalkwasser the hydros turns on the pump but the pump won't start until I turn it on in the kamoer app it has a confirm on notice any thoughts on disabling that feature?

Good afternoon everybody just joined the group. I just purchased a hydros control 4 and would like some guidance on connecting a kamoer Xi pro dosing pump. My question is how do I get to run when the power bar turns on the kamoer app has a start button you need to make the pump run anybody using...