Search results

Danny is correct, just turn alarms on and it alerts when wet.

Sorry if I missed this already being asked. As far as I can tell the new App/software allows an alarm for Protein Skimmer sensor. However, it appears to alert when dry. Shouldn’t alert when wet?

Restart worked. Thanks Carlos.

Like the title says the web and app stauts has lost ability to graph. I have logged out, switched between text, tile, and graph several times. I have not powered off Control 4, wondering if this is next step. Nothing with unit/system has changed since doing update when it came out.

I only have this Amp/Watt meter. Stirrer set on Max (Normally run it at 1/2) - 1 Watt - 0 Amps Register For Comparison I plugged my skimmer in. Vertex Omega 180 22 Watts - 2 Amps

I probably should have mentioned the Power Supply Cord is only 3 feet long.

I ended up changing to midnight after it worked at 11pm. I went to every 30 mins for 2 1/2 mins run time. Because of this I switched the run count to 48 (the max). How would you handle Run Count if you were to go every 15 mins (4 times per Hour)? Or would you have to find another way?

I bought the Intllab Jeff recommended. The control under Generic Output plugged in to wifi strip is working well early on. A bit noisy at times but it is in the basement. Also, a little concerned about ceramic coating on magnet in Seachem Part 2.

It did turn on at 10 pm and shut off at 10:07 (I did 7 mins). Not sure if I will make it until 11 to see if it turns back on.

Will a Run Count of 24 only turn on 24 times. Should it be a Run Count of 0 so it never stops every hour cycle? I did a start time of 22:00:00 so it would start at 10 pm tonight so I could check it.

I received my Magnetic Stirrer today and I want to set it up to run for 5 minutes every hour. It is currently plugged in to one of my Wifi Power Strip Outlets. I started to set it up as a Generic Output with Input Count as Zero (0). I turned Has Schedule on but I am confused by the Advanced...

Found a YouTube video, should work and probably cheap enough to give a try.

It is hard to tell from the description but is the stir plate a simple off/on where the 120v outlet would make it controllable? Also,My wife said she used magnetic stirrers in lab (chem engineer) and they frequently needed a jump start to start spinning. Anyone using these?

My tank overflows to my basement sump and I keep all of my equipment downstairs including my doser which I have not been using very long. Today I noticed a large ball in my coralbox 3 compartment dosing container. I think this is mostly due to my cold basement but also due to not stirring enough...

Thank you Danny. Followed the above but added the ATO Pump (Drive 2) in the drop down for Output device and everything seems to be working ok. Sump level goes low and pump turns on, reservoir level goes low when sump level is low and does not turn on. However, I can not figure out how to make...

I am struggling to figure out the correct settings using Generic with 2 inputs to achieve my desired result. Involved Items ATO Sensor (Input) - Measure sump level ATO Reservoir (Input) - Measure RODI level ATO Pump (Output) - Drive Port 1 pumps from RODI to Sump Goal ATO Sensor goes Dry ATO...

Type=ATO

I have a Water Level Sensor in my sump that when DRY activates my Drive Port Pump to add top off water. Today I added a sensor to my RODI bucket to lmk when the water level drops too low. I am unable to figure out how to have the RODI sensor shut the Drive Port Pump off when the sensor goes dry...

I believe that would prevent the pump from turning on but the Level Sensor would still alarm. Someone else may be better than me to answer tho