Is it possible to create a timer that will turn on Feeding mode for a set amount of time? I would like to set it and then sync my feeder to fire about a minute after Feeding mode starts. This would only be used when on vacation.
When my ATO gets low, I have a notification set. I get the text, and I go fill up the ATO container. I have notifications set to 4 hour repeats. Now that the condition has gone back to normal, I should immediately get a new alert telling me the ATO is no longer low. However, I don't get it until...
I figured it out. Go to the three dots on the right, tap Properties. Save your configuration, then tap Delete Device. Unplug the controller and plug it back in. Now start over adding it back. Once you have it added, you can go to Properties and Load Configuration. It should be easier. They need...
I am using an Orbi Mesh. I found a setting that says allow guests to see each other. I was off by default. I enabled it and now the controller sees the quad. Thanks.
Yes I am using a Mesh and do have a single ID for both 2.4 and 5GHz. I guess you are suggesting that I change the 5GHz? I actually have it on my guest network for safety. I will see if I can just disable the 5GHz on the guest.
To make it clear, I have both the 4 Outlet and the Smart Plug. Both will pair. I upload the changes and that is successful but immediately they show "Not Responding." Any troubleshooting ideas would be greatly appreciated. I am a computer tech so you can get detailed.
I have a new Hydros Control 4. I have tried to get the wifi outlet to work but it always loses contact. I get it paired without issue but in 5 seconds, it says lost contact. I purchased a smart outlet and have the exact same issue with it. Pairing works, says it is paired, I upload the changes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.