Search results

Ya, total system volume 400G Go bigger they said....

I think so. I may need another outlet installed nearby. The tank is on its own circuit currently.

Then the other scenario is the surge protector that the wifi strip are plugged into are overloading and shutting everything down. Now that i think about it more that is probably more likely

Yes, that was me on FB. I didnt mean to start a debate of wifi vs wired. However, i think I figured out the problem. I removed my battery backup but still had the same issue. Then I removed my WE from my collective and only powered my control4 with the appropriate use of terminators but...

Ive had my system setup with Hydros going for close to three months now. Every so often Hydros loses power and then the collective goes broken with the wifi power strips not responding. The power for the building hasnt gone out - only hydros. If I am not physically present to unplug stuff and...

When I get to the end of step 7 and press and hold the mode button, the controller goes to blinking white. If I press and hold mode again it goes back to whatever color it was before

Yes I did. One of the pumps had a bad RF chip. Im waiting on a replacement from Ecotech. I wonder if the other is bad as well

I thought that worked but my Ecotech controllers still dont switch to an orange, cyan, or white signal. They just blink red and blue after I do the pairing step.

That was the step i was missing. Thanks!

Anyone use an AM plank auto feeder? I have one and am wanting to set up the feed drum and water pump to go on certain times of day or when i touch feed mode. Do I create a schedule, a feed mode or set them up as generic outputs? I also want the return pumps and flow pumps to drop down to 1%...

I have done that and gotten up to step 7 but cant get the pumps to pick up one of the three signals. The firmware has been downgraded so that is not the issue. Do i need to do something like set a schedule to make the WE send out a signal?

I noticed that my MP60s have a 3.5mm jack to connect to battery back ups. Can this be used with the 0-10v output to control them? How would you create the output in the Hydros app?

I need some help connecting my MP60s to the WE. Ive watched the video and am only able to get to the step where you pair the pump and the light on the MP blinks blue and yellow. What do you do after this? I have setup the pumps as generic outputs but cant figure out the rest of this. I had...

How do you know what voltage signal to send out to control a device? You are not using the 0-10 out to power a device correct?

Whats the difference between the two? When would you use either one? Im not clear on what you would want the 0-10V In or Out to actually do for you

Is there a way to set up a dosing schedule to dose a different amount every 3rd or 4th week? I have a Kamoer X1 pro that Ive yet to set up. Am i better off programming through the Kamoer app?

I need some help setting up lighting schedules for Radion G5s. Do I select the variable led or just plain led when setting up outputs? When I try to create a schedule the only template I see is for flow schedules. Im having the same issue when trying to creat dosing schedules. Am I in the...

Yes, I have and they are very good. I was just thinking of other ways to make that information accessible.

Still not sure if I need to do this but......a few examples, I have 2 return pumps. Should i use a combiner to group them? I also want my UV sterlizer (lamp and supply pump) to run only if the returns are running. I also have an ozone reactor (generator, air pump, and water pump) that I want...

Whats the difference between the new ATO output you can program vs setting up one as a generic using multiple lvl sensors? I have a direct drive pump governed by 2 lvl sensors in the sump as to when to turn on or off. Should I have set it up differently?