control xp8

I'm looking into getting an XP8 to add to my "Start" and replace my wifi strip. What I was wondering was, do I plug both the Start and the XP8 into a wall outlet for power, or should I be linking them via a command bus cable? Or would both of those provide redundancy? Thanks very much.

🎛️ XP8 Wavemaker Pump Setup (15 min/hr. From 7 AM to 7 PM) 1. Configure the Output (Outputs → Add New) Press the “+” to create a new output. Name: (e.g. “Inside Wavemaker”) Family: Select “Doser” (Using a dosing-family output enables timing control used in step scheduling.) 2. Set Speed Set...

I'm really confused on how to set up the heater so it shuts off once the water reaches a certain temp and haver the fans turn on. Subsequently turn the fans off once the temp is too low and have the heater turn on. So here's what I have: X4 Control with the temp sensor connected to one of the...