water level

  1. C

    Using the "Safety Sensor" level of the Triple Water Sensor for Control

    I'd like the ability to use the "Safety Sensor" level of the Triple Water Sensor as more than just an alert. I'd like to be able to set outputs so that they are off if the water level reaches the "Safety Sensor" or "overfull" level of the Triple Water Sensor. If this is already possible, please...
  2. C

    How to use Triple Level Water sensor to turn off ATO when safety sensor reached?

    I'd like to use my Triple Level Water Sensor 1) to notify me when the sensor is dry and 2) to disable my ATO and Doser outputs when the "Safety Sensor" level is reached. The first was pretty easy, I set that up when I was adding the sensor as an input. The second I can't seem to figure out...
    • CayoHueso
    • Thread
    • advanced alarm ato doser input output sensor triple water level sensor water level
    • Replies: 0
    • Forum: HYDROS Control
  3. J

    Duel ATOs on a schedule

    Looking to add two separate ATOs into one collective. Each would need to be on a schedule. One running while the store is open/ actively selling out of the tanks. This would replenish saltwater back into the system. And the second while the store is closed and would replace evaporated water...
  4. Sawyer B

    Water Level Sensor to Disable ATO

    Hello, is it possible to configure a water level sensor that I have at the bottom of my ATO reservoir to prevent my ATO pump from turning on when the sensor goes dry? For context I’m using the Hydros ATO kit.
Back
Top