waveengine

Hello, I am currently running the X4, and wave engine LE, controllers on my tank. The issues I’m having is whenever I exit feed mode.. the water level in the display takes about 1 minute to get back to the operating water level- is there a way to set a delay on when my gyres start back up again...

Hey, I have a configuration at the moment with two Icecap Batteries, running to a single WaveEngine LE. This is a defined configuration in the Hydros docs, and shown here However, I'm add a second WaveEngine LE, and rather than run a second wire through the wall, I was thinking of: 1...

I have a X4/XP8/WaveEngine collective and use a Reef Octopus 150SSS skimmer. I was disappointed to find that although the WaveEngine can control a RO Varios 2 pump, the WaveEngine outputs are not listed as available to control the Varios 2 (which comes with the skimmer) when the Type is set to...

So I’m leak testing my new 310 gallon system and while doing so I thought I’d start playing around with more of the hydros equipment and getting it set up so that it’s ready to go for when I fill the tank up with saltwater. I have 4 Octo Pulse 4’s along my back wall that I have wired into my...

I now have a hydros control, and a wave engine w etm. I would like to get a gyre, either maxspect or icecap. I have a 6 foot 150 w dual overflow. What’s everyone’s recommendations for the gyre? I’ve never had one, only ever used powerheads. I’m also looking at direct connect powerheads (I can’t...