Wave Engine 2 and Control X4

[Aggiejames]

I purchased a Wave Engine 2 and a Control X4. The wave engine in powering the X4. I apparently didn’t think this through. Is there a way to have the two units “sync” so that when I enable feed on one it also does that on the other? I thought the wave engine powering the x4 would do that by default but I was clearly wrong.

 

[Aggiejames]

Looks like collective was what I needed. All set now.

 

[Danny]

So you got setup? You need the command bus cable and terminators but you also have to create a collective and the controller accessed at the time will be the first member and the collective will retain the settings of that controller. Then other controllers need to be added to the collective one at a time with the app. but any controllers after the first will have any settings erased. That will not be an issue if it is a new controller and you have not setup any outputs or inputs.