A couple of wishes

[WVNed]

1 The ability to reorder things on the status page like the inputs and outputs so you could group them together. I guess they just appear in the order built now?

2 The ability to silence alarms from the app while you clear them.

3 The ability to generate a notification of an event that isnt an alarm like daily AWC completion.

I am new to this so if you can do some of these things now excuse me.

Thanks

Ned

 

[Carlos]

1) Already done with Pages. HYDROS Control - Pages
2) Good suggestion, and I will add it to the feature request.
3) That is also a good feature that we are already working on it. At this time, AWC is not natively supported, so a notification is not triggered.

 

[WVNed]

1) Already done with Pages. HYDROS Control - Pages
2) Good suggestion, and I will add it to the feature request.
3) That is also a good feature that we are already working on it. At this time, AWC is not natively supported, so a notification is not triggered.

Awesome
I will investigate Pages more deeply.

I programmed an alarm for my AWC but then found I couldn't silence it so I took it out.

I am already doing AWC and used it as an example but was more thinking about non emergency events I would like to be notified of. If I program something new to happen regularly I would like to be notified of it for a while until I trust my programming. Then I could turn it off again.

Thank you

Ned

 

[Danny]

Awesome
I will investigate Pages more deeply.

I programmed an alarm for my AWC but then found I couldn't silence it so I took it out.

I am already doing AWC and used it as an example but was more thinking about non emergency events I would like to be notified of. If I program something new to happen regularly I would like to be notified of it for a while until I trust my programming. Then I could turn it off again.

Thank you

Ned

I only use the alerts via the app. I have nothing at the local alert setting or email. You will get the original alert then it will repeat on the repeat time set until it clears. That has not been an issue for me. I tired setting the leak detector to local and one night we lost internet in the middle of the night. My wife woke me up complaining about the alarms so that killed that idea.They are set back to orange now. There were no leak detectors active so not sure why it tiggered the local for no internet.

 

[WVNed]

I don't mind alarms if there is one and I like to know when I cleared it.

As I said I would also like to be able to know something I programmed is working without sitting and watching it.

 

[Danny]

I don't mind alarms if there is one and I like to know when I cleared it.

As I said I would also like to be able to know something I programmed is working without sitting and watching it.

I use a relay to trigger a switch input on my Archon if I cannot be there to watch things when testing. That way I have a graph of the output in question. I guess I could also use a spare sense port to do the same on the Hydros. I normally don't have the spare sense port though. Since I converted almost everything to the Hydros I have plenty of spare inputs on the Archon.