Hydros Control 4 - Low Power Mode

[MauroGzz]

In the options of my Hydros Control 4 I see 2 options:

* Low Power Exit Delay 00:00:00
* Low Power Mode Unused

Could someone explain to me how they work or what they are for?

 

[Carlos]

Here you go:

HYDROS Control - Using Low Power Mode on a Battery Backup

The HYDROS is compatible with 12V backup batteries. It detects when it's on battery power and runs pumps at a reduced intensity to extend battery life.

www.coralvuehydros.com

 

[MauroGzz]

Here you go:

HYDROS Control - Using Low Power Mode on a Battery Backup

The HYDROS is compatible with 12V backup batteries. It detects when it's on battery power and runs pumps at a reduced intensity to extend battery life.

www.coralvuehydros.com

Thanks Carlos, I had already seen this page, but I still have doubts, because I don't have a WaveEngine, I can't follow those instructions, I have control 4

 

[Carlos]

Without the WaveEngine, there isn't much the Control X4 can do as far as low power mode. It can shut off devices, but the devices would already be off if the power is out. The Control X4 does not power 24V devices as the WaveEngine does.

 

[MauroGzz]

Without the WaveEngine, there isn't much the Control X4 can do as far as low power mode. It can shut off devices, but the devices would already be off if the power is out. The Control X4 does not power 24V devices as the WaveEngine does.

Ok, so for now I can forget about those settings, right?

As long as I don't have the WaveEngine it's not much use.