Water Change Stopped Working

[ABursiek]

So i had my AWC setup and working flawlessly the past few weeks. The last 2 days the pumps show they are on when they are scheduled to in auto mode but they aren't actually on. No voltage or watts being shown. So they just run until they reach the maximum allowed time. I can changed them from auto to On and then they work as they should. Not sure why they are doing this. Attached are pictures of them in auto and on to show what i am talking about.

 

[ABursiek]

Disregard. I rebooted my collective and its back to normal. Not sure why it did that.

 

[Danny]

Are the outputs on a different controller than the wifi master? If so try rebooting both.

 

[ABursiek]

Well, it worked last night fine after i rebooted the collective, now this morning its back to the same issue. Not sure whats going on here, or why its doing this.

 

[Carlos]

Do you have the correct time zone set?

 

[ABursiek]

Do you have the correct time zone set?

Yes, Chicago time zone

 

[Carlos]

Do the logs show the last time the AWC ran?

 

[ABursiek]

Yes, as you can see the fill timed out after 45 minutes but it never filled anything. When i was awake i had to manually set it to on to fill the water back up.

Do the logs show the last time the AWC ran?

 

[Carlos]

Do you have a "Max Time On" set? If the pump has to run longer than the max time, it will cause issues. So ensure that it is set to longer than the pump will need to run.