Recent content by bcoco

Ok Sorry i thought when i enabled reverse a year or 2 ago that these modes had reverse in them. if they do not i stand corrected and will go ahead with my selections. back then i know i enables reverse on my gyre and during sps it was stopping and not really reversing. so i will give it another...

Yes, but i do not see a place to enable reverse mode on sps or lps. And i believe that schedule runs pumps in reverse if the pump it self is switched to enable reverse. i do not want to run reverse on the sps and lps, just on my constant that i will set up.

That part i understand, but i usually run a combo of sps during day and lps at night. i believe both of these have reverse in them. but i do not want them to run in reverse in these flow patterns. i only want the reverse to happen when i set up this schedule. thanks carlos

Is there a way to run a 4k gyre in reverse only in certain flow modes? i would like to set up a schedule where i can run my pump in reverse for 10 minutes a day, but do not want it to run in reverse during my normal flow patterns ex. not in sps flow mode. if you choose constant speed there is a...

today my 4k pump running off the wave engine, in a collective with C4, locked up. when i went to the app the icon was flashing error. it was correct, needed to be cleaned. Question is are we going to be able to have this situation notify us ? it did when i entered the app, but i cannot find...

not on the pump

Now that the wave engine is part of the collective, very easy to do i might add. Is there a place where you can be notified if a pump is locked up? i know it use to show you on the status screen, but i do not see a place where yo can set a "pump locked" notification.

i know you cannot use the wave engine as your main device. but if you have a c4 and wave engine in a collective and the c4 goes down, can the wave engine still operate the wifi strips thru the collective? Or doing this makes it easy to control everything together, but no redundancy. And can you...

thats what i thought.

Should you plug the wifi strips into a gfi outlet, or is this unnecessary ?

thanks, easy hook up. the apex cable to the box then set the 0-10v in wave engine.

that would make sense.

i'm not sure. it says connecting apex to the 0-10v input on the wave engine, but i would need to hook to the output 0-10, i think?

Do you have any idea of what cables, and how, to hook this aqualink adapter to the control 4 0-10v output ? i do have a 1-0-10v quad cable, but i think the apex would be rj45 into the adapter?

So, if you run power supply to your wave engine and power a control 4 from the wave engine, you need 2 terminators ? one on the open buss connection on the wave engine, and one on the open buss on the control 4 ??