Recent content by Bruce_K

After updating the “schedule” “days of week” selection is not functional. I had scheduled dosing certain days of the week….

The other option to “sync with current version” is to re-select the control unit or collective from the top left menu. First select menu which will show the choices Status, devices, input, outputs,etc. Now click the down arrow beside the name of your device or collective This will show list of...

I would review setup instructions: HYDROS Control - How to Add a Dual TDS Meter - the input will read once every hour - also you can specify an “offset” if the reading is not the same as your other meter.

I have an iPad mini 2 running iOS 12.5.5 and Hydros App version 2.2.0 (209) firmware 192. The iPad is mounted by the hydros Control units at my tank. Works great!

Try press and release Press and release the “Mode” button to set the ETM pump controller to different positions. WHITE = Same Side ORANGE = Opposite Side CYAN = Back

What Carlos said - confirm your version of the WE is Ecotech …. If it is - I would try to follow the written instructions here: https://www.coralvuehydros.com/product-support/hydros-waveengine/ecotech-marine-vortechs/ Make sure you do step 5 - if they stay blue/red check distance from...

Yes create a schedule and add the pump - https://www.coralvuehydros.com/product-support/hydros-waveengine/add-flow-pump-schedule/

I would follow these instructions - if your pump is new you probably need to downgrade it from Ecotech Möbius … https://www.coralvuehydros.com/product-support/hydros-waveengine/ecotech-marine-vortechs/

Regarding Doser - Does Hydros have a doser released for sale? From instructions: Here is what you’ll need to get started: A Simple Doser Pump Information on the pump’s dosing rate. How many milliliters per minute does the pump run when powered? An open WiFi outlet (Drive Port if using a...

Thanks - Great information for the forum! I did the basic setup using Control 2 and added the TDS using a Control XS port for TDS. Water pressure is high at my house so I don’t need a pump.

Yes 👍

https://www.coralvuehydros.com/product-support/hydros-control/hydros-collective-101/ Look at Figure B in redundant power supplies section. Wave Engine can power the control 4 & xs using (power & data) command bus cables. Terminator goes on one wave Engine bus. Then a data only cable from 1st XS...

Not sure how you identify? I’m sure Coralvue will help you if you provide the model power supply you have! Link to purchase: HYDROS Control Power Supply

Someone can confirm this but From the photos it looks like the control 4 is not connected to the 2 XS units as you have power supply cable and a terminator. For your setup I believe you want all 3 units in your collective correct? If so, I would get the power supplies with a built in terminator...

Check the active in modes selection - make sure your “normal” mode is checked