Dual Inline TDS Sensor not working, staying connected

[rballjunkie]

I've had this for a few weeks. Cannot get it to read consistently and to stay on. It sometimes provides one of the two TDS readings and only shows 0 PPM for the other. I tested my RODI and it's not 0 ppm. It will stay on for a while, then disconnect itself. I have tried to connect to a different sense port, still does not work.

Is anyone else having this issue?

 

[Danny]

That sensor only comes on once an hour for a reading if I remember correctly. The secondary reading will not graph. Only the primary reading. This one should be on the DI output and should read 0 TDS unless your DI stage is depleted.

 

[Bruce_K]

I would review setup instructions: HYDROS Control - How to Add a Dual TDS Meter

- the input will read once every hour - also you can specify an “offset” if the reading is not the same as your other meter.