Danny's latest activity
-
Danny reacted to afboundguy's post in the thread Allow child outputs to be referenced in Combiners/Depends with
Like.
@Danny I actually have this delay relay timer I used for my DIY RODI flush that I think will work perfectly - -
Danny replied to the thread Allow child outputs to be referenced in Combiners/Depends.I am not sure if you can get it to work that way but you can try it and see how it reacts. I was doing RODI control with mine before...
-
Danny replied to the thread Allow child outputs to be referenced in Combiners/Depends.For now if you are good at DIY you can always attach a relay to the same output that powers the flush solenoid and connect the switch...
-
Danny replied to the thread Splitting drive cable to power more than one item?.Which drive ports have a 1.5a-2.5a rating per port. The X4 and X2 it think are just 1a per port or a max of 1.5a between the 2. It will...
-
Danny replied to the thread Audible alarms being triggered without notification or email..Try setting up an output an use the inputs one at a time on it. Use the generic output type but turn on enable advanced settings and set...
-
Danny replied to the thread Alarm Logging.If it is audible then it has to be an alert level that has audible turned on. Normally that would be a red alert. How many inputs or...
-
Danny replied to the thread Firmware 374.I never had more than 2 EcoTech pumps in my collective. I recently switched them out for OctoPulse 2 pumps. Still only have 2 of them...
-
Danny replied to the thread Firmware 374.When I click on the arrow for position in the schedules I get the selection menu and I am on firmware 374. Did you setup a output for...
-
-
Danny replied to the thread Blenny Dosing Pump schedule help.You would need to use a separate schedule if it has a different dose amount. In a schedule there is only one dose amount for all dosers...
-
Ok so that seems to have worked. I tested it and the pump didn't stutter like it was and ran. We will see tomorrow when the water drops...
-
Danny replied to the thread Hydros Launch.Yes you will have to pull the plug but you will have to pull the plug on either the power supply or any other controller that has power...
-
Danny replied to the thread Hydros Launch.Power it down but if it is part of a collective you will have to power down the whole collective. That should do a power down reboot.
-
Danny replied to the thread Hydros Launch.Have you powered down the Launch and powered it back up? If it is in a collective you will need to power down the whole collective.
-
Danny replied to the thread Hydros Launch.Do you have something else that works on the drive ports that you can try there?
-
Danny replied to the thread Aurora V12 with Extension Question.The Kraken Outputs are only the force ports which are 24v DC and drive ports which are 12v DC. On battery power the force ports only get...
