Danny's latest activity
-
Danny replied to the thread Firmware 374.When I click on the arrow for position in the schedules I get the selection menu and I am on firmware 374. Did you setup a output for... -
-
Danny replied to the thread Blenny Dosing Pump schedule help.You would need to use a separate schedule if it has a different dose amount. In a schedule there is only one dose amount for all dosers...
-
Ok so that seems to have worked. I tested it and the pump didn't stutter like it was and ran. We will see tomorrow when the water drops...
-
Danny replied to the thread Hydros Launch.Yes you will have to pull the plug but you will have to pull the plug on either the power supply or any other controller that has power...
-
Danny replied to the thread Hydros Launch.Power it down but if it is part of a collective you will have to power down the whole collective. That should do a power down reboot.
-
Danny replied to the thread Hydros Launch.Have you powered down the Launch and powered it back up? If it is in a collective you will need to power down the whole collective.
-
Danny replied to the thread Hydros Launch.Do you have something else that works on the drive ports that you can try there?
-
Danny replied to the thread Aurora V12 with Extension Question.The Kraken Outputs are only the force ports which are 24v DC and drive ports which are 12v DC. On battery power the force ports only get...
-
Danny replied to the thread Ato/awc cycling.Glad to hear it is resolved.
-
Danny replied to the thread Ato/awc cycling.It still would not hurt to have others check it and see if they notice anything that might be causing your issue. I assume you have...
-
Danny replied to the thread Ato/awc cycling.You changed a setting from twice a week to once a week? Could that have been what caused the issue to show up? My AWC is split into 4...
-
Danny replied to the thread Kraken 24V Force Port extension cable?.I do that for power to my lighting but my lighting is a DIY LED fixture. I may have made my own cable at the time since the Kraken was...
-
Danny replied to the thread Hydros power alert 0 watts.Have you tried rebooting the XP8 from the right menu under device properties?
-
Danny replied to the thread No Push Notifications from Launch.Try turning them off in options. Then do the upload changes. Then wait a couple of minutes and then turn them back on again and upload...
