Recent content by Travisr100

Emailed support. They said it was a problem for all users caused by some changes/work they were doing. They corrected it. My graphs are good now.

I was having a graphing issue as well. Emailed support. They said it was a problem for all users caused by some changes/work they were doing. They corrected it. My graphs are good now.

For some reason my graphing has stopped. My graphs are only updated through 2 days ago at 10 AM. The tiles are all updating normally. Any clues?

@BluJ thanks for that info from Hydros. Helps with the understanding.

No, salt tank was definitely not low. I haven't seen this behavior again here lately. I'm keeping an eye on it though.

I will add that on my AWC settings the fill pump is set to a max run time of 22 minutes. It looks like it hit that max run time for some reason which is odd. It usually only takes 12 minutes or so. However the level in the sump currently is clearly at the top sensor. And the fill keeps...

I have my AWC set to run three times each day starting at 9 AM. For the past few days it’s been running fine. The AWC will run and change the water and then after that the ATO will run as necessary to top off until the next AWC. That’s all as expected. This morning, however, at 9 AM the AWC...

I see you made an edit to your post earlier and I was just about to say the same thing. It seems to go to idle when the upper sensor goes wet and the runtime hasn't expired. At least now I know what it represents.

Do you know what the idle entries represent?

I’m confused by these logs. I would expect to see turned on, running, and turned off. Why all these idle entries?

Makes total sense. Not initially intuitive but makes sense. Still not sure why the internal schedule wouldn’t run more than once even when set to three times but the external schedule seems to be working properly.

This has been my experience exactly. With the triple level sensor the ATO was only running maybe 3 to 4 times a day and I saw more water drop than I care for between running. I switched to the optical single sensor and now it runs more like the Tunze I had. It's actually running TOO often...

So after changing to an external schedule early this morning (set to run 3 times a day), also set to begin at 9:00 and end at 17:00, it did indeed run 3 times. It ran at 9:00, 11:40, and 14:20. Can anyone explain why? I would assume that it would run at 9:00, 13:00, an 17:00.

Confirmed. It's 374 on all devices.