Search results

So I'm wondering why your outputs in use show up on the device screen but mine (for example my sump light) don't, even though sump light is clearly in use.

Here's a screenshot of my sump light and the device input port it uses. And here's a shot of the device, not showing the input.

Still not showing up on the X4.

Sorry, my bad. They are connected to the 0-10v input, channels 1 and 2.

Hi, I have a float switch and a sump light connected to my ControlX4 0-10v outputs 1 and 2. They work perfectly. But when I look under Devices for the X4, it reports that all the 0-10v outputs are Unused. Not a big deal, just wonder why it happens that way.

Thanks!

This evening my web app suddenly asked me to log in. I did. It logged me in. Then I got "Unable to Connect." Nothing has changed in my setup. I have: - rebooted access point - rebooted main router - tried up upload changes (failed) - rebooted my computer - hit the reload button on my browser...

I have my 24v devices all plugged into a WaveEngine and my 120v devices (return pump, skimmer) plugged into a Control XP8. They are connected in a collective. Both are externally powered. And both are plugged into an APC Battery Backup. In case of a power failure, at full draw, the APC will...

How about some rheostat-like slider outpuur that would show up on the status page and allow for easy changing the speed on pumps, skimmers, etc.

I can't really tell. It's a gyre, set up opposite end from another gyre. So it's hard to see exactly what is ramping up or down. But that second column is minutes, right?

Sorry for what is probably a dumb question, but when setting cycle durations, what do the columns mean? So do I have a one minute cycle? It's the last .000 column that confuses me. Thanks.

Hi Carlos, I downloaded and installed the firmware, and reset my overrides. All OK except on my doser reservoir, I've lost the "reservoir remaining" value and can't see how to restore it. It says reservoir remaining 0.0 but it's still half full. Thanks, Arch

Thanks for the quick reply. Turning pumps off is no problem. My problem is that the ATO reservoir is higher than the sump and dosing pumps, so I'm worried about a tubing connection leak and gravity siphon into the area below the tank.

My RO/DI reservoir has a float valve and automatically refills. It has a longish tubing to the tank area, where a dosing pump pulls the water from the reservoir as needed. I would like to use a leak detector under my aquarium where the dosing pump is, so if one of these lines leaks, the...

Me too! A simple start time in mode configuration? That plus the existing timeout would be great!

Last night all the lights on my collective (wave engine, x4, xp8) all went dark. But everything seemed to be working OK. Rebooted the collective: no joy. Unplugged/replugged: no joy. Web app couldn't make connection. Did not reboot router. Then this morning, lights were suddenly back on. All...

Thanks Danny. Do you know of a continuous on solenoid that wouldn't heat up?

I have a gravity feed ATO system and need a safety solenoid. So if my 1/4" RO/DI tube leaks, and my leak detector detects it, I want to be able to shut off the tube. I would use the Hydros solenoid but don't have a free drive port. Is there a third-party solenoid setup I could use in...

I sent in a ticket. This is the second xp8 I've had trouble with. Hydros sent it to me to replace a defective one. Great customer service, problem device.

So I'm trying to add my new xp8. I see it on the app, but when I select it to add/register it, I get the strange message: "There can be only one! My spidey senses that the email address you've entered does not match the one registered to this device." I'm trying to add the device so...