Search results

half of it is, the other half holds it to the cup on the inside

So, the skimmer sensor doesnt work about 90% of the time. Seems the only way to make it work is to remove the magnetic eye piece that goes inside the skimmer cup. Anyone experience this issue. If i remove that piece and just drop the actual sensor in water it works. With that piece on in water...

Yes, upon completing the water change it is adding water and filling past the sensor. Im trying to figure out why it would turn on right after the water change when the sensor is wet. You would think seeing the sensor is wet, it wouldnt allow the pump to turn on.

But the main question here is, how do i prevent the pump from turning on as soon as the water change is done. Do i just set a minimum on time of 1 sec, or leave at zero.

Im not really sure how often it turned in before. I just set the water change system up today. I really dont want it to turn on at all as soon as the water change is done. I only want it to turn on when its called on by the high water sensor.

I disabled all the advanced settings now until i can figure out if that was my issue. Thoughts?

My ato pump is the hydros pump that runs off the drive, not the 43ml dosing pump. That pump does about 1.2 gallons a minute.

Yes, i had it set for a minimum time of 15 seconds and a max of 30. I assume that is why it turned on right away?

OK, so im now totally confused. I have the auto water change system working based on my high and low level sensors in my sump. It drains to the low level as it should, then it fills to the high level as it should. As soon as that is done it then turns on my ATO pump and starts filling my sump...

Thank you for that. I had the ato working properly the same way you have it set up. Just stopped working when i setup the awc System.

I just set this up last night so there isnt much to show, but when i woke up that is when i noticed the ato was not working.

I was just thinking the same thing. I adjusted the time on the awc schedule now from 9am to 9am. I have it scheduled to change water 6 times a day at 15 minutes each. I will keep an eye on it and see if it fixes it after the 1st scheduled start.

Picture shows example of high sensor dry and pump not on.

So I finally got around to setting up the awc. I am using 2 hydros dosing pumps and a hydros top off pump. I added an additional low level sensor to my return area in my sump. Before i set this up i was using the ato setting with a single sensor and it worked perfectly. Now that i have the awc...

I cant speak for anyone, but obviously there are part shortages everywhere you look.

I will give this a try and report back. Thank you.

i tried doing it literally right next to it. My 1st one worked instantly when it was installed under the tank

Yes i do, but i even tried disabling the 5 ghz as well as connecting my phone to the same mesh as the system and it still fails.

Well the problem now is i cant get it to pair. I have BRS sending a replacement

No, i was just trying to add an outlet through the app and it wouldn't power on. When i manually hit the power button it turned the outlet on and then went off right away. I removed it from system as something didn't seem right and now once again i am having a hard time trying to add it. It...