Search results

I am starting to regret this hydros system. Since day 1 i have had bad sensors, bad wifi outlets, numerous error messages, and now for the 2nd day in a row i get collective broken. Yesterday i unplugged everything and did a hard reboot and that fixed the issue. Now today it is doing it again...

So i had my AWC setup and working flawlessly the past few weeks. The last 2 days the pumps show they are on when they are scheduled to in auto mode but they aren't actually on. No voltage or watts being shown. So they just run until they reach the maximum allowed time. I can changed them from...

Can the hydros dosing pump be powered by one of the usb ports on the wifi power strip. I have no more drive ports or wifi plugs available. I figured i could just splice in a usb plug into the cable.

So, the skimmer sensor doesnt work about 90% of the time. Seems the only way to make it work is to remove the magnetic eye piece that goes inside the skimmer cup. Anyone experience this issue. If i remove that piece and just drop the actual sensor in water it works. With that piece on in water...

So I finally got around to setting up the awc. I am using 2 hydros dosing pumps and a hydros top off pump. I added an additional low level sensor to my return area in my sump. Before i set this up i was using the ato setting with a single sensor and it worked perfectly. Now that i have the awc...

So im trying to add another Wifi X4 power strip to my collective, but no matter how many times i try it fails and timeouts. I cant seem to get it to work. My 1st one i added worked flawlessly. Im doing it exactly as the directions say to do. Any suggestions here.

So, i just set up my ato and it worked for an hour so as it should, only to eventually receive a notification that my ato reservoir is empty. My ato pump overfilled the return area way passed the water level sensor. Not sure why this happened. Here are some screenshots on how i currently have...

I am new to this hydros system and am confused on how to set things up. The whole depends on has me confused. I have a sensor in my ato container of the sump and want my solenoid valve to open and fill up the reservoir when the sensor is dry. The solenoid is hooked up to a drive port.

So i added a skimmer sensor and the only option for notifications is to alert when dry. This sensor should obviously be alert when wet. How do i go about changing that? Im using android if that matters.

So i want to use 2 drive ports to power 12 v pumps to do auto water changes. Both pumps will be upstairs under the tank by the sump. I want one to pull water from the sump and send it to the basement and the other to pull new salt water from the basement to the sump. Anyone know if they are...