Search results
-
C
Auto Water Change “Inactive”
I figured this right before I saw your post! It worked once I checked Normal for ATO Active Modes, and make sure the ATO was on Auto in the Status page. ATO Output Device didn’t need to be setup to any drive port or outlet (set to None), so the auto water change started even without this. I...- corynactis
- Post #3
- Forum: HYDROS Control
-
C
Auto Water Change “Inactive”
Hello! Totally new to Hydros, and recently bought a Hydros Start to be a heater controller and to create an auto water change, but it reports my AWC setup as “INACTIVE” and I can’t get it to run on a schedule. The setup is: • Two triple water level sensors (high and low levels) connected to two...- corynactis
- Thread
- Replies: 2
- Forum: HYDROS Control