ato

Hey everyone, I recently got the Launch for my 90G cube and it's been great so far. I got the Hydros triple ATO sensor kit to replace my Tunze and one of the features I was hoping for was to figure out how much RO water is being filled in my tank over time from my reservoir. Is there any way...

Does Maximum On/Off time in the Outputs relate to the actual amount of time a device is running? Does it work off of power draw? Or is it just correspond to how long the "output" is powered by the Hydros controller? Example: I'd like to create an output for my Tunze Nano ATO. I'm going to set...

I'd like to use my Triple Level Water Sensor 1) to notify me when the sensor is dry and 2) to disable my ATO and Doser outputs when the "Safety Sensor" level is reached. The first was pretty easy, I set that up when I was adding the sensor as an input. The second I can't seem to figure out...

Looking to add two separate ATOs into one collective. Each would need to be on a schedule. One running while the store is open/ actively selling out of the tanks. This would replenish saltwater back into the system. And the second while the store is closed and would replace evaporated water...

I ran a water level sensor from my X4 to a lower section of my ATO container. When dry, the ATO pump shuts off which keeps me from accidentally burning up the pump. I also have a generic output device that monitors if that sensor is wet. If dry for 5 min, I get notifications (Orange level...

Hello, is it possible to configure a water level sensor that I have at the bottom of my ATO reservoir to prevent my ATO pump from turning on when the sensor goes dry? For context I’m using the Hydros ATO kit.