0-10v. float problem

[archgetty]

Hi,
So I connected a float switch via the 0-10v cable, exactly as Carlos showed on the video. But when I tested the float, in either up or down position, it jumps back and forth between wet and dry every few seconds, even when I don't move the float. I tried 2-3 volts instead of 1-3 , but still have the problem. Any ideas?

 

[archgetty]

Update: I added the analog voltage tester for the channel, and when the float is down, voltage is 2.49-2.51. Report dry/wet bounces around independently.
When the float is up, voltage is 0.0 and always shows wet (correctly).

 

[Danny]

Update: I added the analog voltage tester for the channel, and when the float is down, voltage is 2.49-2.51. Report dry/wet bounces around independently.
When the float is up, voltage is 0.0 and always shows wet (correctly).

How do you have the input setup? Can you post a screenshot?

 

[archgetty]

How do you have the input setup? Can you post a screenshot?

 

[Danny]

Try setting it to 0-1v and wet when inside range.

 

[archgetty]

Try setting it to 0-1v and wet when inside range.

That worked. Thanks!