0-10v not dimming T5

[Gcrom]

So i have set up the 0-10v and used port 3 for my dimmable t5 fixture but controller does not dim the light or run it at anything other than 100%. Is that a software thing or a fix that is coming?

 

[Danny]

I think that has been discussed on another thread. I will see if I can find it.

 

[Danny]

Ok here is a link to a thread where they discuss this Need help with setting up 0-10v on a control 4 . The thread is concerning pumps but they discuss this bug. The next firmware release should fix it.

 

[Gcrom]

Ok here is a link to a thread where they discuss this Need help with setting up 0-10v on a control 4 . The thread is concerning pumps but they discuss this bug. The next firmware release should fix it.

Is that the update that is suppose to come out today?

 

[Danny]

Yes, it has been delayed till Wednesday during the day.

 

[Skwerl]

I installed and am running the new 177 version, but my 0-10v light outputs still do not work. They only go up to 1.0v when overridden to 100%.

 

[Carlos]

I installed and am running the new 177 version, but my 0-10v light outputs still do not work. They only go up to 1.0v when overridden to 100%.

Submit a ticket at CoralVue Support Portal and I will look at your device tomorrow and see what the issue might be. Sorry for the inconvenience.

 

[Gcrom]

Submit a ticket at CoralVue Support Portal and I will look at your device tomorrow and see what the issue might be. Sorry for the inconvenience.

I am having the same issue. Used my volt meter and 100% only reads 1 volt