0-10v quad cable

[bcoco]

Do we know what each segment of the 3.5 jacks are on this cable. I see 3 segments. I'm trying to find out which is + and - on this. want to hook it up to a t5 ballast, its an ati rtro kit, So there is the + and - screw on connections. i figure i'll just get a female end and wire that to the ballast.

 

[JeffB418]

They should be wired as follows:
- Tip = 0-10V output (+)
- Ring = unused
- Sleeve = Ground (-)

Also channel mapping:

• BLACK = Direct Output 1
• BROWN = Direct Output 2
• RED = Direct Output 3
• ORANGE = Direct Output 4

Hope that helps.

 

[bcoco]

thanks, that's exactly what i was looking for. didn't want to have to cut a new cable.

 

[Carlos]

It is also on the instructional website. It is at the bottom 3rd of Step 2 in this page:

HYDROS Control - How To Add a Variable Light

Here we will show you how to add a Variable Light to your HYDROS Control

www.coralvuehydros.com

 

[bcoco]

It is also on the instructional website. It is at the bottom 3rd of Step 2 in this page:

HYDROS Control - How To Add a Variable Light

Here we will show you how to add a Variable Light to your HYDROS Control

www.coralvuehydros.com

thanks, didnt see that before.