0-10v unused?

[archgetty]

Hi,
I have a float switch and a sump light connected to my ControlX4 0-10v outputs 1 and 2.
They work perfectly.
But when I look under Devices for the X4, it reports that all the 0-10v outputs are Unused.
Not a big deal, just wonder why it happens that way.

 

[Danny]

You should have the float switch on a input and not an output. A 0-10v output will not power a light of any kind. Is it a sump light switch that you are referring to? if that would also be a input and not an output.

 

[archgetty]

You should have the float switch on a input and not an output. A 0-10v output will not power a light of any kind. Is it a sump light switch that you are referring to? if that would also be a input and not an output.

Sorry, my bad. They are connected to the 0-10v input, channels 1 and 2.

 

[archgetty]

Still not showing up on the X4.

 

[Danny]

Were are you not seeing them? Do you have a screenshot? What is it that is not showing up?

 

[archgetty]

Here's a screenshot of my sump light and the device input port it uses. And here's a shot of the device, not showing the input.

 

[Danny]

The 0-10v inputs do not show on the device screen. Here is a screenshot of mine. I have all 4 of the outputs in use so they are there. I do not think they show if they are not used.

 

[archgetty]

So I'm wondering why your outputs in use show up on the device screen but mine (for example my sump light) don't, even though sump light is clearly in use.

 

[Danny]

The screenshot you have displayed is a 0-10v input setup and not a output. Do you also have a output setup with the same name? If so post a screenshot.

 

[archgetty]

OK, got it. Thanks.