Connect wireless dual pump controller to the control

[Scharapenko]

Is there any benefit to connecting the icecap controller via the 0-10v on the control compared to just running them through the hydros app?

 

[Carlos]

The only benefit would be to be able to start Feed mode on the Control and have the IceCap Controller do the same.

 

[Zuck]

Is there an instruction page on how to do this? I’d like the icecap WiFi controller to enter/exit feeding and water change modes at the same time as the control 4.

 

[Danny]

Here is the instructions in the online manual Activate Feeding Mode from HYDROS Control - HYDROS

 

[Zuck]

I have followed these instructions. The WiFi controller enters feed mode but does not exit the feed mode and return to normal mode upon timeout. I rebooted and it wouldn’t exit feed mode. I had to pull the input cable and then reboot to return to normal mode.

The instructions do not specify if a timeout or exit delay is required, so I tired adding both of these for 10 minutes (same as x4). No luck.

I’m running a control 4 and the icecap WiFi controller with v192.

What am I doing wrong?

 

[Danny]

Does the output you created on the Hydros controller go off when Feed Mode completes?

 

[Zuck]

I figured out that I don’t needs this feature. The x4 does it all.