Disable alarms for feed and water change

[BigHatFannyPack]

Is there an easy way to disable or mute notifications for pump, ato, etc. based on status?

I set my collective status to water change or feeding and am greeted by so many alarms!

Happy to attach screenshots of anything as needed and TIA!

 

[Danny]

I only have push notifications setup on mine and I just ignore them on my iPad and phone. If you are getting a audible alarm on the controllers you can setup an output using the alert type for the alerts. Then you can override them to off before you put it in the modes causing the audible alarms. I have not tried it to see if it will stop the push notifications. Just make sure and put them back in auto once done.

 

[BigHatFannyPack]

I only have push notifications setup on mine and I just ignore them on my iPad and phone. If you are getting a audible alarm on the controllers you can setup an output using the alert type for the alerts. Then you can override them to off before you put it in the modes causing the audible alarms. I have not tried it to see if it will stop the push notifications. Just make sure and put them back in auto once done.

Thanks for the reply. I determined the root cause and adjusted some notification severities. My high level water sensor was being tripped when the return pump shut off and so the notifications were functioning as they should! Chalk this one up to being a novice and user error. The good news is I'm able to keep all setting the same and position the sensor a little higher in the tank and not have to remember/forget to turn notification warnings on/off