DiYers, help me find this!

[Hooz]

I'm doing a DiY Hydros 4 channel doser, and I'm having trouble finding a a small terminal/power distribution block. I've found some on Amazon, but they're larger than I want and, since space is at a premium for this project, I'm looking for smaller.



This is 2 pole (I'll be using for DC +/-), and it has 12 terminals per side. I only need 5 for each side, so this is basically twice what I need. The only other qualification I have is that it accept 22awg wire.

I've been through Amazon, and I'm currently wading through AliE, but I figure there has to be some digital electronics supply that has what I need, so I'm reaching out for some help!

 

[KWolfe81]

I'm doing a DiY Hydros 4 channel doser, and I'm having trouble finding a a small terminal/power distribution block. I've found some on Amazon, but they're larger than I want and, since space is at a premium for this project, I'm looking for smaller.


This is 2 pole (I'll be using for DC +/-), and it has 12 terminals per side. I only need 5 for each side, so this is basically twice what I need. The only other qualification I have is that it accept 22awg wire.

I've been through Amazon, and I'm currently wading through AliE, but I figure there has to be some digital electronics supply that has what I need, so I'm reaching out for some help!

I realize this post is several months old but no-one ever responded. This should be very easy to DIY. You'll want to buy some 0.1" (2.54mm) spacing screw terminals such as these and then some PCB prototype board. Cut to size, solder two rows down, solder wire connectors over. Done.

 

[TanAsh]

Not sure if you still looking for one.

PCB007 1X 12 Position Power Distribution Board 2 Inputs 2 x 13 Outputs for DC AC Voltage for model railroad NEW

Amazon.com