Firmware 244

[Carlos]

Firmware 244 is now available for the following devices:

• Control X4
• Control X2
• Control XS
• Control X3
• Control XP8
• WaveEngine
• WaveEngine v2
• WaveEngine LE
• IceCap WiFi Controller

This firmware fixes an issue with override communications within a collective consisting of devices with different firmware revisions.

IMPORTANT:

NEVER, EVER, EVER update your firmware if you are not in the same location as your controller.

Firmware 244 requires App 2.3.4. To update to firmware 244, you must first download App 2.3.4 from the app store. If you are using the web app, please clear your browser's cache so it updates to the new app as well.

On Vacation and Need Access to App 2.3.2?
If you are on vacation and cannot update the firmware right away, you can always access your devices via the Web App (Previous). Note that if you update the firmware, you will not be able to use 2.3.2.

Installation Instructions:

Step 1: Download the new version of the app from your app store
Step 2: Download firmware 244 on ALL devices first before installation
Step 3: Install firmware 244 on ALL devices at the same time

Please visit the CoralVueHYDROS.com website for more in-depth instructions on downloading and installing the new firmware.

Full Changelog

 

[Fishface1970]

Thank you @Carlos, followed these instructions and had no problems at all with this update.

 

[mppp78]

Firmware 244 is now available for the following devices:

• Control X4
• Control X2
• Control XS
• Control X3
• Control XP8
• WaveEngine
• WaveEngine v2
• WaveEngine LE
• IceCap WiFi Controller

This firmware fixes an issue with override communications within a collective consisting of devices with different firmware revisions.



Installation Instructions:

Step 1: Download the new version of the app from your app store
Step 2: Download firmware 244 on ALL devices first before installation
Step 3: Install firmware 244 on ALL devices at the same time

Please visit the CoralVueHYDROS.com website for more in-depth instructions on downloading and installing the new firmware.

Full Changelog

Ever since installing this 244 update my units have been stuck in override modes? Any ideas how to fix this?

 

[Danny]

Manually put them in auto.

 

[mppp78]

Doesn't work unfortunately. When I click on auto for both pumps it goes to 0 and override screens are grayed out? (See attached)

 

[Danny]

What about the schedule for the pump?

 

[Carlos]

Doesn't work unfortunately. When I click on auto for both pumps it goes to 0 and override screens are grayed out? (See attached)

Are you in read-only mode? Did you share, or did someone share access with you?