how do set a delay on my gyres?

[HALFISH99]

Hello, I am currently running the X4, and wave engine LE, controllers on my tank. The issues I’m having is whenever I exit feed mode.. the water level in the display takes about 1 minute to get back to the operating water level- is there a way to set a delay on when my gyres start back up again after exiting feed mode? I’ve tried everything!!! I’m just tired of the water splashing unnecessary for a few seconds…. Hope that makes sense…. Nothing seems to help I’ve tried everything !!

I’m using two Ice cap 2ks

 

[HALFISH99]

????

 

[Hooz]

I want to do the same thing. Also want to delay the skimmer turning back on for a few minutes.

 

[Danny]

Are you manually entering feed mode? If you use the depends on to turn off an output and set the minimum off time it will not start that countdown until the depends on has been released. otherwise the minimum off time count down will start as soon as the output turns off. I use the depends on on my skimmer and have it dependent on the return pump and have a minimum off time set for 10 minutes. That way when the return pump is off it will automatically turn off the skimmer. The skimmer will not start back up until the return pump has been back on for 10 minutes.