Issue adding hydros doser

[tonybuonantuono]

Have an existing control X3 and added control x2 and a hydros doser and configured it. Could get it power on when doing manual dose. In troubleshooting I realized I did not add x2 to the collective.
I have since added but still not working.
Issue I believe is out put device options are only showing wifi outlets and not drive ports. How can I correct?

 

[tonybuonantuono]

If I go under existing x3 settings I was able to add to drive port 1 and do a manual dose. The doser is now the only input or output showing. All others are in the new collective.

 

[tonybuonantuono]

Inputs

 

[Danny]

Are you sure the X2 is in a collective? For a collective you will need a command buss cable and at least one terminator. When you have the collective selected which should be the only choice if all your controllers are in the same collective like mine. Below is a screenshot where you would normally select the controller you want access to. I have 10 controllers all in the same collective named Aquarium Control. It is the only selection I can select. Also in the second screenshot at the top of the status page for the collective all my controllers are shown with status just below the collective ok banner. If both of your controllers are not there the one that is not is not in the collective.

Edit: according to you screenshots you X2 is not in the collective since it shows up on the selection menu. If it was in the collective it would no longer be there.

 

[tonybuonantuono]

Yes. That was my issue. Wasn't in collective. I'm good to go now

 

[Danny]

So you are able to select the drive ports now?

 

[tonybuonantuono]

Yes,thank you