Jebao OW-25 compatibility
- Thread starter Bmoore
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)
- Admin
- #2
No, unfortunately, there isn't one. So the only way to control Jebao pumps is to use their 0-10V junction box and connect them to the 0-10V output on the WaveEngine.
CaliFarrow
New member
Hi Carlos! What part numbers are needed for this set up?
- Admin
- #4
You need to purchase the Jebao 0-10V junction box, which they sell themselves. You need to make sure the pump model you have works with it. As far as HYDROS cables, you will need the following:
osvaldogarza21
New member
I was looking to do the same I’m on the Jebao.com website can’t seem to find the junction box 
Fishoutofwater
New member
There is no way to run that directly/indirectly from the wave engine, even with the APX adapter. The old fishstreet/jebao to apex adapter is no longer in production I believe. Even if it was it’s not compatible with the newer sine wave pumps. The aualink’s through Reefbr**ders that work through the apex aren’t compatible with that pump either.
I know this because I’m in the bind where I had been running 4 jebaos off my Wave Engine and as they have been dying as the jebaos do rather often I’ve lost connectivity because of the new tech not being compatible with the old adapters.
I’m down to 2 left still running and am looking at some DIY options myself to re-intigrate back into my setup the newer pumps. I’ve been playing with the SW-15 controllers because they have a so called 0-10v input port. And in typical jebao fashion it’s not the right style plug, it doesn’t work properly with input without tearing it apart and modifying it as well.