MGarrison
Member
Hello Everyone,
So today I was doing some maintenance on my Kamoer X1 Pro2. When I went into settings I saw a new setting "Connect to Controller"!
This setting is not in the Manual.
When you click on it there is a QR Code. Anyone know what this is for? Is this the ground work for Hydros to control dosing pumps?
Thanks,
So today I was doing some maintenance on my Kamoer X1 Pro2. When I went into settings I saw a new setting "Connect to Controller"!
This setting is not in the Manual.
When you click on it there is a QR Code. Anyone know what this is for? Is this the ground work for Hydros to control dosing pumps?
Thanks,