Need Help Creating New Mode

[Jasontkd]

I am trying to set up a new mode or schedule that I can manually engage that would override my normal schedules similar to how feeding mode works.

I am wanting to create a mode (or something) where I can clean my powerheads in buckets of citric acid. So, I would want them to run, but only at 25% or so, and at a constant speed. With the new firmware (186), I am not sure how to do this.

Ideally I would create a mode with no timeout but I don't know if this would work. Would I be able to do this, or would l need to create new schedules or something?

 

[tdg910]

This could be done previously but I’m not sure how to do it with the new schedules and modes. I’m trying to make a mode button that overrides the current gyres schedule and runs the pumps at 100% until i press the normal mode button. Thoughts?

 

[Carlos]

Create a new Schedule that runs the pumps at 100% constant speed and make the schedule ACTIVE only in the mode you want. Make sure your regular schedules are NOT active on the special mode.

 

[tdg910]

Create a new Schedule that runs the pumps at 100% constant speed and make the schedule ACTIVE only in the mode you want. Make sure your regular schedules are NOT active on the special mode.

@Carlos if I only want reverse to work on one schedule (eg hurricane), is this correct? Enable reverse on the pumps and only enable it on that specific schedule (hurricane)?

 

[Jonapiaqacharil]

Was it possible to program individual parts? I think it has already been calculated. So that there is no increased wear of some parts.