I have 2 control x4s, which work great independently. They are connected by powered command bus cable with terminator at the end. I created a collective with the primary x4, and a collective is ok with only that x4, but I add the 2nd x4, following the directions on the getting started page, and the collective breaks and constantly 'cycling' between each x4. I am unable to use the collective until I remove the 2nd x4.
I have included a video of what I am doing and what happens.
Both x4s are running firmware 192.
Any input and recommendations are appreciated
Andrew
I have included a video of what I am doing and what happens.
Any input and recommendations are appreciated
Andrew
