Pump Error Message Wave Engine

  • Thread starter Thread starter RobT
  • Start date Start date
  • Tagged users None

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Don, I'm using an Ipad, but I did check and I'm using the next to last version but to be fair to me it was updated to 2.2 only this week. Anyway, I got the Varios 2 and Octo Plus wave head running in the sink. I was a bit thrown off at first because initially the Varios 2 went to a pulse of water than pump error and repeat but after me changing the schedule and speed, it settled into steady run. The Octo Pulse ran from the get go. Now to put my control board back together and test our the Varios 4 and get this tank up and running. Thanks for your help. BTW, Had I know you were in Florida not that far from me, I could have saved the time and shipping i.e. I wasted two + weeks due to Hurricanes and the PO office losing the W/E for a week. . rob
 
An update: After 2+ months of dealing with W/E problems, I now have my 120 gallon tank up and running. Only thing left to do is set up the Coral Vue ATO, Skimmer Float switch and PH probe.
I was a bit concerned at first because after I moved the W/E and pump to the display tank after testing it out in the sink, it did a similar pulsing pump error. I deleted the Output and corresponding schedule and set up an new output and schedule and it ran as designed. This is the same thing I had to do when I received it back from C/V i.e. sink testing. I'm running the latest software and firmware using an IPad mini.
 
You must log in or register to reply here.
Back
Top