Replacement tips/barbs for hydros drive port dosing pump

[heliousc6]

I've been having tough luck with dosing pumps lately. I broke the little barb fitting that joins the tubing in the head to the dosing line. Where can I get more of these? What size are they actually? While I'm at it has anyone figured out how to adapt the the I/o of this pump to standard 1/4 od hard tubing

Is the pump just like a kamoer f1? For parts purposes

 

[JeffB418]

I've been having tough luck with dosing pumps lately. I broke the little barb fitting that joins the tubing in the head to the dosing line. Where can I get more of these? What size are they actually? While I'm at it has anyone figured out how to adapt the the I/o of this pump to standard 1/4 od hard tubing

Is the pump just like a kamoer f1? For parts purposes

Please reach out to support@coralvue.com

 

[Danny]

I used 3/16" to 1/8" barb fittings to go from Hydros dosing pump tubing to RODI tubing.

 

[heliousc6]

I ended up buying a replacement dosing head ( which I'll eventually need) and it came with the barbs

 

[jhov2324]

I used 3/16" to 1/8" barb fittings to go from Hydros dosing pump tubing to RODI tubing.

View attachment 4320

Can I use 3/16" x 3/16" barb on that doser for liquid food?

 

[Danny]

Can I use 3/16" x 3/16" barb on that doser for liquid food?

Not sure you could get the dosing pump tubing over a 3/16" barb fitting. I think that is the 1/8" side is for the doser.

 

[LQ1]

the barbs are 3/32 x 1/8

 

[Sole83]

For replacement barbs on the Hydros dosing pump, the correct size is 3/32" x 1/8". You can get them by buying a replacement dosing head, which comes with the barbs included. For adapting to standard 1/4" OD hard tubing, you can use step-down barb fittings like 3/16" to 1/8" or check with Coralvue Support for compatible adapters.